Makefile

The corner runs for one testbench. Copied into sim/<CELL>/.

Set at the top: TB=tran (the testbench name), VIEW=Sch (switch to Lay for post-layout), CELL, LIB and OPT. It includes make/sim.make for the netlist targets.

make alone runs typical etc mc summary.

Target	Corners
`typical`	`Gt Ktt Tt Vt`
`slow`	`Gt Kss "Th,Tl" Vl`
`fast`	`Gt Kff "Th,Tl" Vh`
`tfs`	all three process, temperature and supply corners: 27 runs
`etc`	`Gt "Kss,Kff,Ksf,Kfs" "Th,Tl" "Vl,Vh"`: the 16 extreme combinations
`ntc`	`Gt "Ktt,Kss,Kff" Tt Vt`, process only
`temp`	`Gt Ktt "Tt,Th,Tl" Vt`, temperature only
`mc`	30 Monte Carlo runs at `Kttmm Tt Vt`
`test`	`typical` with `OPT="Debug"`

Every one of them depends on netlist, so the netlist is always current. Results land in output_${VIEW}_<target>/.

Then:

summary runs cicsim summary --output README.md, which builds the result table from summary.yaml and tran.yaml
slide turns that README into a slidy HTML deck with pandoc
clean removes the output directories, *.run, *.pdf and *.csv